Comparison

T101LIOL

Intelligent transducer with integrated signal conditioning and digital IO-Link interface, Measuring stroke ± 2 mm, Pretravel not adjustable. Pneumatic push. Plug DIN M8, cable exit axial.

Articlenumber

1005950

Datasheet

Product Image

Properties

Total Stroke, Measuring stroke, Pretravel default setting, Bearing, Lifetime, Tip rotation, Temperatur range, Mounting position, Tip, Bellow, Body diameter, Plug, Cable feature

Total Stroke

4.6 mm

Measuring stroke

± 2.0 mm

Pretravel default setting

symmetrical, not adjustable

Bearing

Ball bearing, no side-play

Lifetime

> 10 Mio. Cycles

Tip rotation

1° over full stroke

Temperatur range

-10 to +65 °C, storage and operation

Mounting position

any

Tip

Ø 3.0 mm tungsten carbide ball, M2.5 fixing thread, exchangeable

Bellow

none, (air gap seal)

Body diameter

8h6

Plug

M8, 4 pin, Port Class A

Cable feature

PUR shielded, Pig-Tail Length 200 mm
Advance, Lift off, Pressure Pmax, Pressure P application, Spring rate, Spring rate information

Advance

pneumatic

Lift off

return spring

Pressure Pmax

4.5 bar

Pressure P application

1.1 bar

Spring rate

F = f(p) N

Spring rate information

apx. 1.0 N at 1.1 bar / apx. 0.6 N at 0.8 bar (at el. zero)
Repeatability, Error limit, Measuring rate, Power supply, Power consumption

Repeatability

0.05 µm

Error limit

±1.0 µm (at 20 °C ±1 °C)

Measuring rate

150 measurements/ sec

Power supply

24V

Power consumption

120 mW
Measuring system, Data interface, Connection to electronic device, Transmission rates, IO-Link process data, Configuration

Measuring system

Plunger, Inductive Half Bridge. Integrated conditioning with system error correction

Data interface

IO-Link specification 1.1 COM3

Connection to electronic device

Plug connection M8 screw-lock, 4 pin

Transmission rates

IO-Link Spezifikation 230,4kBit/s

IO-Link process data

The probes only have „process data out“ data. These are 32 bit wide and correspond to the position of the measuring pin in nanometers, signed.

Configuration

It is not necessary to configure the probe for operation. According to IODD, a rolling average filter can be configured starting at address 0x0040 of the ISDU. Possible values for the averaging time are 0 to 100 ms.
Documents information

Documents information

All drawings and 3D models are shown in "electrical zero" position.